This Ceramic Tiled Floor was in Penarth near Cardiff, the tile were 150 mm x 150 mm red dust pressed composition, known as versatile as it can be laid on both sides sometimes found around swimming pool areas due to their non-slip raised definition. The floor was looking a bit tired, so the customer asked if they could be revived. I did an inspection of the floor and noticed the grout was loose at the lounge doorway and this had to be re-grouted after my wet vacuum sucked it out part way through the cleaning process.

Cleaning Ceramic Tiles

First of all I tested for moisture which read very low, which was good news as it meant I was not going to have any issues with moisture in the tiles. I then applied masking tape to the skirting and carpet riser at the bottom of the staircase; I always protect these areas as once I removed a little paint on another customers skirting with Tile Doctor Remove and Go and so I deducted £50 .00 off the bill by way of compensation.

I then covered the floor with Tile Doctor Remove and Go let it soak in for half an hour, the floor was then rinsed twice and then to clean the grout I applied with Tile Doctor Pro-Clean which was then scrubbed into the grout joints; it was at this point some lose grout came away. The floor was rinsed twice again and I re-grouted the areas which needed it. The floor was dried with a wet vacuum and then it was left to dry for two days.

Sealing Ceramic Versatile Tiled Floor

On my return I checked the damp levels again before starting to seal the floor with three coats of Tile Doctor Seal and Go which also adds a nice shine to the tile. Caution should be applied to this type of tile as streak marks can be prominent when applying the sealer, in my experience I find as soon as the sealer is applied to the tile with a paint pad a cloth or any other method it marks the tile. It’s possible I’m just a being a perfectionist as the customer was thrilled with the finish.

Source: Residential and Commercial Tile and Stone Maintenance in South Wales