Dealing with Mould in Ceramic Shower Cubicle

The photographs below are from the bathroom of a house in the Moston area of Manchester which is primarily residential and only 3 miles away from the city centre. My customer had been primarily concerned with the removal of unsightly mould but was also keen to have the grout in the ceramic tiled shower cubicle given a good deep clean.

Ceramic Tiled Shower Cubicle Before Restoration Moston Ceramic Tiled Shower Cubicle Before Restoration Moston

Cleaning a Ceramic Tiled Shower Cubicle

To clean the Shower Cubicle, I used a strong dilution of Tile Doctor Pro Clean which is a strong alkaline cleaner that works really well on grout. The Pro-Clean solution was decanted into a spray bottle and then sprayed onto the grout lines and left it to dwell. The air in the solution makes it lighter and easier for it to stick to vertical surfaces.

After a few minutes the Pro-Clean was scrubbed in using a stiff grout brush. The tiles were then rinsed with water to remove the soiled solution from the tiles and the process repeated where required.

Although cleaning process was a success there were still a few mould marks left so to tackle these I used Tile Doctor Mould Away spray using the same process of scrubbing and rinsing. The Mould Away spray did the trick for me and I moved on to remove the silicone around the shower cubicle. When removing silicone, you must make sure you get all mouldy silicone out otherwise it can spread from the old to the new.

Ceramic Tiled Shower Cubicle During Restoration Moston

After I had finished removing the silicone I tidied the shower cubicle and used a bit of gentle heat from my heat gun to dry the grout lines and edges where silicone used to be.

Grout Colouring a Ceramic Tiled Shower Cubicle

I used my damp tester to make ensure there was no dampness anywhere around the working area and then moved on to colouring the grout which would give the whole shower a fresh and consistent appearance. On this occasion, I used a White colour from the Tile Doctor range of Grout Colourant’s, it’s an epoxy based colourant that protects and rejuvenate the grout lines.

I had to use 2 coats of colourant to get the best result and then moved on to putting new silicone around the shower base with a high-quality mould resistant silicone. When finished adding fresh silicone I tidied up again and the job was complete.

Ceramic Tiled Shower Cubicle After Restoration Moston Ceramic Tiled Shower After Restoration Moston

I think you can’t argue the shower cubicle was transformed and customer even said it looks better then when it was new; we also fixed few chips for her whilst there and stripped and replaced the silicone around the sink as a bonus.

Ceramic Tiled Sink Grout Before Cleaning Moston Ceramic Tiled Sink After Cleaning Moston

 
 
Source: Ceramic Tile and Grout Cleaning Service in Manchester

Refreshing the Appearance of Shower Tile and Grout

Shower and bathroom mould and soap scum growth are probably the most common, annoying and frustrating tile-related problems. Wet and high humidity areas with poor ventilation provide the perfect breeding ground for mould and stains. Soap residue and body oils also create a food source for soap scum, mould to grow.

My customer in Dane Bank had the exact problem with dirty and mouldy grout lines in her shower cubicle. She had tried scrubbing the grout lines herself with a toothbrush and standard supermarket cleaners but never got the result she wanted.

Shower cubicle before refresh in Dane Bank

Fortunately she was lucky to find Tile Doctor from the internet and I was asked to pop over and take a look to see what could be done. I was confident we could make a big difference so I went through the options with her and give her price for the job. She was happy with the price and we agreed a date for me to return and complete the work.

Shower cubicle before refresh in Dane Bank

Cleaning a Ceramic Shower Cubicle

For grout lines cleaning I used Tile Doctor Grout Colorant Pre-Treat Cleaner, which successfully removes dirt, soil, soap scum and hard water deposits from grout joints. The product was sprayed on to the grout and left to dwell and seep into the pores for approximately five minutes to break down the soap scum and dirt before being scrubbed in using a stiff grout brush. The cleaning was successful but there were still few mouldy spots left. On these spots I used Tile Doctor Mould Away Spray that is meant for quick removal of mould from grout and silicone. One again product got sprayed on grout lines and left to dwell for five minutes and then scrubbed with stiff grout brush and then rinsed with clean water. After I had finished cleaning I express dried the tile and grout using high power heat gun.

Grout Colouring in a Shower Cubicle

With the area nice and dry, I had to choose the matching colour for the existing grout. There are ten colours to choose from the Tile Doctor range of Grout Colourant and on this occasion we chose Limestone as the best colour to match the tile.

Shower cubicle after refresh in Dane Bank

The colourant is easily applied directly to the grout and in this case I applied two coats. The product is epoxy based and completely seals and rejuvenates the appearance of the grout, which not only drastically improves appearance it also makes it much easier to clean in the future. After applying the re-colourant I buffed all grout colorant excess off the tiles and the shower cubicle was ready.

Shower cubicle after refresh in Dane Bank

My customer was very satisfied with the work and left the following comment on the Tile Doctor Feedback system

“Really, really happy with the service Tony provided and the recommendations he suggested. The work was carried out in a highly professional manner, to a high standard. I have already recommended him to friends. Thank you”
 
 
Source: Shower Tile Cleaning and Renovation Service in Greater Manchester

Refreshing the Appearance of a Ceramic Shower Cubicle

Shower cubicles can be the most difficult of tiled features to keep clean. Most are exposed to various acid-based soaps and shampoos on a daily basis, allowing mould and general muck to quickly build up along the grout lines and silicone. This leaves the entire area looking quite unappealing. In some cases, the grout lines become stained beyond a point where they can be restored to their original condition, so property owners will typically request to have the grout cut out and replaced however a faster and cheaper method is to have the grout completely recoloured.

Such was the case with this Ceramic tiled shower cubicle at a house in Wigan. It would take a lot to get the cubicle looking great again, having not been cleaned properly for a long time. The property owner decided to contact me for a professional refresh, including cleaning, new silicone sealer and recolouring of the grout.

Ceramic Shower Cubicle Before Refresh Wigan

Cleaning a Ceramic Tiles Shower Cubicle

I started the refresh by applying Tile Doctor Mould Away spray to the tiles and grout, and leaving it to dwell for an hour. As the name of the product suggests, Mould Away is a fast and effective cleaner for the removal of mould from silicone and grout, making it ideal for use on shower cubicles similar to this one. I then rinsed the entire area down with water before scrubbing the grout lines and tiles with a stiff grout brush to remove any remaining mould and lime scale, leaving them looking a lot cleaner.

Colouring Grout in a Ceramic Tiles Shower Cubicle

The cleaning process made a big improvement however the grout was still too stained so after removing the silicone strip from around the base of the shower I proceeded to recolour with our white Grout Colourant. The colourant is painted onto the grout and any excess is wiped of the tile before it dries which both improves the appearance of the grout and seals it in to protect it from further staining. The last step was to apply fresh white silicone along the base of the shower.

Ceramic Shower Cubicle After Refresh Wigan

The customer was very pleased with the refreshed appearance of their shower and you must admit it looks much more inviting now.
 
 
Source: Ceramic Tile Clearing and Restoration Service in Greater Manchester

Giving a Ceramic Tiled bathroom a facelift

This Ceramic tiled bath with shower was installed at house in Didsbury, this customer wanted to give the bathroom a facelift and not usually it was the grout rather than the ceramic tile that had discoloured, the silicone also needed to be replaced due to the mould build-up and if you get mould on silicone it’s impossible to remove and can only be replaced. Unfortunately mould build-up in bathrooms is quite common in the UK due to our damp climate and modern insulated homes that restrict air flow. If you’re having this problem yourself consider installing a more powerful extractor fan or simply leaving the door to the bathroom open more often.

Disbury bathroom tile and grout refresh before

Cleaning Tile and Grout

The Ceramic tiles and grout were treated using a strong 2:1 dilution of Tile Doctor Pro-Clean which is a highly recommended Tile and Grout cleaning product; being alkaline it’s safe to use on all sorts of tile and stone surfaces. For vertical tiled surfaces I recommend the mixture is decanted into a bottle with a trigger spray attachment which when sprayed onto the wall allows the cleaner to mix with air making it lighter and allowing it to stick better. The solution was then worked in using a stiff scrubbing brush by hand before being rinsed off with water; this process was repeated a number of times until we had managed to clean all the areas and then left to dry. If you’re doing this work yourself then you should know that Tile Doctor produces a product that comes with a spray attachment called Oxy Pro that is ready to use and can save you some time.

Whilst waiting for the tile and grout to dry the Silicone Sealer was removed using a sharp knife, as I mentioned before once mould gets a grip on silicone it will need to be replaced. It’s also worth mentioning at this point that silicone will last longer if the residue from soaps, shampoos and body washes etc. are rinsed away with clean water after having a shower as it’s the chemical and not the water that damages the silicone in the first place.

Grout Colouring

Cleaning the grout had made a visible difference and improved the overall look of the bathroom but it wasn’t showroom condition so to improve it further it was necessary to apply a white Grout Colourant. The product we use is epoxy based and forms a thin impermeable barrier over the grout so not only does it look good it protects the grout as well; it’s very easily applied using a small brush along the grout lines and you just wipe of the excess so it wasn’t long before the grout was looking like new.

Last step was to re-new the silicone sealant around the top of the bath and the job was finished; my customer was very pleased with the results and made the comment that she thought it looked like new.

Disbury bathroom tile and grout refresh after

 
 
Source: Bathroom refresh company in Manchester